![]() ![]() You can easily pass your custom SPI pins to the library constructor. Serial.print(bme.readAltitude(SEALEVELPRESSURE_HPA)) Serial.print(bme.readPressure() / 100.0F) ![]() Serial.print(1.8 * bme.readTemperature() + 32) Serial.println("Could not find a valid BME280 sensor, check wiring!") (you can also pass in a Wire library object like &Wire2) Adafruit_BME280 bme(BME_CS) // hardware SPIĪdafruit_BME280 bme(BME_CS, BME_MOSI, BME_MISO, BME_SCK) // software SPI *īased on the Adafruit_BME280_Library example: When using libraries to interface with your SPI peripherals, it’s usually simple to use custom SPI pins because you can pass them as arguments to the library constructor.įor example, take a quick look at the following example that interfaces with a BME280 sensor using the Adafruit_BME280 library. Important: make sure you select the board you’re using in Tools > Board, otherwise, you may not get the right pins.Īfter uploading the code, open the Serial Monitor, RST your board and you’ll see the SPI pins. put your main code here, to run repeatedly: put your setup code here, to run once: Make sure you have the right board selected in Tools > Boards Find the default SPI pins for your board The above copyright notice and this permission notice shall be included in allĬopies or substantial portions of the Software. Of this software and associated documentation files. Permission is hereby granted, free of charge, to any person obtaining a copy If you’re not sure about your board’s default SPI pins, you can upload the following code to find out. Finding your ESP32 Board’s Default SPI Pins ![]() Whether your board comes with pre-assigned pins or not, you can always set them on code. Note: usually, when not specified, the board will use the VSPI pins when initializing an SPI communication with the default settings. Additionally, some boards don’t have pre-assigned SPI pins, so you need to set them on code. So, make sure you check the pinout for the board you’re using. Warning: depending on the board you’re using, the default SPI pins might be different. The pin mapping for most boards is as follows: SPI Many ESP32 boards come with default SPI pins pre-assigned. HSPI and VSPI have independent bus signals, and each bus can drive up to three SPI slaves. You can use HSPI and VSPI to communicate with other devices. SP0 and SP1 are used internally to communicate with the built-in flash memory, and you should not use them for other tasks. The ESP32 integrates 4 SPI peripherals: SPI0, SPI1, SPI2 (commonly referred to as HSPI), and SPI3 (commonly referred to as VSPI).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |